Rustins Brick & Tile Matt Red Paint2.5L & 5L (Matt Red)

Rustins Brick & Tile Matt Red Paint is a quick-drying paint that bonds exceptionally well to brick and tile, producing a durable and weather-resistant matt finish.

The paint can be used for a range of masonry applications such as walls, cement, stone, tiles and bricks - both interior and exterior. It is pigmented with micronised red oxide to give good opacity and exterior durability.

During preparation, the bricks should be free from dust and contaminants. Brush the bricks with a wire brush to remove any existing finish, which may be flaking and to remove any loose particles and mortar.

A coat of alkali-resisting primer must then be applied and allowed to dry before applying Rustins Quick Dry Brick & Tile Paint. No primer is required if fresh mortar has been applied to the pointing and if painting new brickwork.

Use a large brush and apply evenly. Apply paint liberally, making sure the surface is covered completely.

A single coat is usually sufficient, but a second may be applied if required.

Drying time is approximately 30 minutes, depending on temperature and humidity. Re-coating time is approximately four hours. Ideal application temperature is 15-25°C. Do not apply if rain imminent.

Coverage is 14 sq.metres per litre per coat.

Rustins Brick & Tile Matt Red Paint is sold in 2.5L and 5L containers.

Full product data sheets and safety data sheets are available on request.

Product: Quick Dry Brick & Tile Paint
Type: A high quality acrylic matt red paint.
Intended Use: For interior and exterior brickwork and tiles. (Refer to compatibility section below).
Special Features: Quick drying and pigmented with micronised red oxide to give good opacity and exterior durability.
Preparation: The bricks should be free from dust and contaminants. Brush the bricks with a wire brush to remove any existing finish, which may be flaking and to remove any loose particles and mortar. Fill cracks and repair damaged pointing. If the brickwork shows signs of efflorescence (white crystals on the surface), it must be removed by brushing or scraping. A coat of Alkali-resisting Primer must then be applied and allowed to dry before applying Rustins Quick Dry Brick & Tile Paint. No primer is required if fresh mortar has been applied to the pointing and if painting new brickwork. If applying to existing painted brick test for compatibility as if not compatible it may flake off or dry to a glossy finish.
Application: Use a large brush and apply evenly. Apply paint liberally, making sure the surface is covered completely.
Coats: 1 coat is usually sufficient. A second coat may be applied if required.
Drying Time: Approximately 30 minutes, depending on temperature and humidity.
Re-coating Time: Approximately 4 hours
Application Temp: Ideally 15-25°C. Do not apply if rain imminent.
Coverage: 14 sq.metres per litre 1 coat.
Maintenance: The surface may be washed with a mild detergent solution and a scrubbing brush and re-coated if necessary.
Compatibility: May be applied over other paints but test for compatibility as the paint may dry glossy. Refer to manufacturer’s advice before applying paint to roofing tiles. Unsuitable for use over glazed tiles.
Settlement: STIR VERY WELL BEFORE AND DURING USE, or the product may dry with a satin or gloss finish.
Shelf-life/Storage: Many years if stored in original tightly closed container in normal conditions.
Hazards: Keep out of reach of children. Avoid contact with skin and eyes. After contact with skin, wash immediately with plenty of soap and water or a proprietary skin cleanser. A full Safety Data Sheet is available upon request or on Rustins Web site.
Clean-Up: Remove excess product from brushes before cleaning. Clean brushes whilst wet with water. Hard brushes can be cleaned with Rustin’s Brush Restorer.