Flag Anti Slip PU Floor Paint5 Litres (2 Colours)

Flag Anti Slip PU Floor Paint has a high-quality resin system with a very fine textured finish, sold in 5 litre tins.

It is suitable for application to most surfaces and will provide a hard-wearing, water and oil-resistant finish.

This paint is ideal for general walkways, factory and garage floors.

Before application, the surface must be stable, firm, dry and free of dust, sand, loose old paint, dirt, grease and oil.

It is touch dry in 2-4 hours, ideally at temperatures around 20°C. Over-coating time can take place after 16 hours. Do not exceed five days for over-coating.

Theoretical spreading rate is around 12-15 sq. metres per litre (depending on surface).

Full product data sheets and safety data sheets are available on request.

*Note: This product has anti-slip properties and therefore provides slip resistance. However, it is not possible to guarantee a totally non-slip surface.

Sealing/Priming: It is only necessary to seal a porous substrate such as new or bare concrete. A sealer coat is achieved by adding 10% white spirit to the paint. Please note new concrete floors can only be painted after 6-8 weeks.
Area of use: Interior and exterior (not suitable for all exterior applications)
Substrates: Concrete, stone and wooden floors
Colours: Green 14C39, Grey 00A05
Finish: Semi gloss
Volume solids: 50%
Theoretical spreading rate: 12 - 15 sq. metres per litre (depending on surface)
Flash point: 38°C
Specific gravity: 1.4
Dry to touch: 2 - 4 hours (20°C)
Over-coating time: 16 hours (do not exceed 5 days for over-coating)
Application method: Brush or roller
Thinner: White Spirit
Cleaning of tools: White Spirit
Surface condition: The surface should be stable, firm, dry and free of dust, sand, loose old paint, dirt, grease and oil.
*The theoretical spreading rate has been calculated for the stated volume solids and dry film thickness. A practical spreading rate will depend on the actual dry film thickness, the nature of the substrate, and the relevant consumption factor. The physical constants are subject to normal manufacturing tolerances.